Product Description
In order to complete a Pike Arms® Takedown Style Barrel, you will need the stripped barrel as well as the barrel hardware. The Pike Arms® Takedown Barrels are sold without the associated takedown barrel hardware so if you already have the required additional parts, you are not forced to purchase them. However, if you need the barrel hardware or don't want to take it off of a Ruger factory barrel, the barrel hardware parts are available. Each part is billet CNC machined then professionally either hard anodized or blued to ensure exceptional durability and reliabily and are ready to be installed on your Pike Arms® Takedown barrel. None of the parts are cast or MIM injection molded.
Product Videos
Custom Field
Product Reviews
2 Reviews Hide Reviews Show Reviews
-
I would have liked to give this 5 stars but I had to sand the pin down because it was super tight.
The takedown pin needed some fitting.
-
Takedown hardware
Ordered two in separate orders. The first was tight but managed to get it loosened up enough to actually function. The second one was horrible. I had to use a drill bit to open the hole enough for the pin to even move. Before doing so it would get stuck 1/4 inch in. I then had to remove all of the anodizing from the pin using a drill and a scotch brite pad. I finally got it to function properly after about 30 minutes worth of modifications. It seems like a good product but Pike needs to do some quality control on these.